Sources and Specs Posted

February 25th, 2008 Comments Off on Sources and Specs Posted

I posted the Sketchups for the 3D printer, the motor controller board and what I have of the decomposer plugin. You can fetch the sources here:

svn co http://www.ooeygui.com/Arduino .

The Decomposer doesn’t work yet. I had been working under the assumption that Sketchup performed true volume intersections. Well, it doesn’t – it only performs edge intersections. If you attempt to intersect a voxel in the middle of the model, there’s nothing generated. This requires a minor change in plans. My original discussion mentioned a slice, then a strip then a voxel, but I tried to short circuit it in code; my mistake.Something for another night.

Comments are closed.

What's this?

You are currently reading Sources and Specs Posted at OoeyGUI.

meta