Comments for OoeyGUI

Comment on Arduino Plugin for TextMate by madaerodog (Craciun Constantin)

madaerodog (Craciun Constantin) — Thu, 28 May 2009 03:47:28 +0000

RT @harkopen:nice #arduino plugin for textmate http://www.ooeygui.com/?page_id=207 from @ooeygui

Comment on Arduino Plugin for TextMate by jotbe (jot*be)

jotbe (jot*be) — Thu, 28 May 2009 03:25:01 +0000

RT @harkopen:nice #arduino plugin for textmate http://www.ooeygui.com/?page_id=207 from @ooeygui

Comment on Arduino Plugin for TextMate by harkopen (Harkopen.com)

harkopen (Harkopen.com) — Thu, 28 May 2009 02:53:16 +0000

nice #arduino plugin for textmate http://www.ooeygui.com/?page_id=207 from @ooeygui (keep up the good work) we will be reading u

Comment on Arduino Plugin for TextMate by baramunchies (Jan)

baramunchies (Jan) — Sun, 26 Apr 2009 22:12:27 +0000

Arduino Plugin for Textmate http://www.ooeygui.com/?page_id=207

Comment on Arduino Plugin for TextMate by textmator ( Textmate Tips)

textmator ( Textmate Tips) — Sun, 26 Apr 2009 17:34:45 +0000

OoeyGUI ” Arduino Plugin for TextMate http://tinyurl.com/9gzto8

Comment on Grid Beam Workbench by David Cary

David Cary — Fri, 17 Apr 2009 15:37:17 +0000

If you are looking for a “standard hole spacing for small parts”, perhaps one of these standards will be adequate:
* Grid beam: “hole spacing is equal to the width of the material.” — most commonly, 1.5 inch (38.1 mm)
* Erector, Marklin, Meccano, Vex Robotics: 1/2 inch hole spacing (12.7 mm): “Half Inch Systems Group (HISG)”
* Merkur, Eitech: 10 mm hole spacing
* Mignon: 6 mm hole spacing

Comment on Fabr motherboard by ooeygui (Lou Amadio)

ooeygui (Lou Amadio) — Mon, 13 Apr 2009 13:55:14 +0000

Fabr’s motherboard – http://www.ooeygui.com/?p=307

Comment on Grid Beam Workbench by lou.amadio

lou.amadio — Fri, 03 Apr 2009 00:26:44 +0000

The Grid beam standard really only says that hole spacing is equal to the cross section, with end holes at half cross section. I was looking into grid beam for various sustainable projects, one of which was potentially as a frame for repstrap (although, continuing to use 80/20 T-Slot for stability reasons)

Comment on Grid Beam Workbench by fenn

fenn — Thu, 02 Apr 2009 11:58:51 +0000

hello. could you please look in yon book and tell me if there are any standard gridbeam sizes below 1 inch?
I would rather build my (repstrap) project to conform to any standard that already exists, rather than just make up my own. i was thinking 1/2″ or 3/4″ square aluminum tubing with 1/4″ or 3/8″ holes spaced one beam width apart.

Comment on RepRap Arduino Firmware refactor by lou.amadio

lou.amadio — Fri, 27 Mar 2009 15:34:06 +0000

Funny you should mention… I’m creating a post about this today.